911������

The U.S. economy remains mired in the worst downturn since the Great Depression, but recent indicators suggest that demand for many manufacturing products at least started to stabilize in the first quarter. For most plastics processors, this means that 911������ levels will flatten out at the current low levels for the next few months. Now that the economic trends have started to establish firm bottoms, expectations about the future will become more optimistic, and both 911������es and consumers will respond with increased buying activity.

Featured Content

How Vacuum Drying Is Revolutionizing Plastics Processing READ MORE

AI-Driven Capabilities Advance Efficiency and Quality in Your Molding Environment READ MORE

A Simpler Way to Calculate Shot Size vs. Barrel Capacity READ MORE

MODEST GROWTH IN 2009

The uncertainty that gripped consumers at the end of last year was clearly evident in the charts of both our Film Business Index and Sheet Business Index (both available at www.ptonline.com). These indicators are designed to measure total North American output of these products. The severity of the downturn during the second half of 2008 (the steepness of the down slope) was the most pronounced in the history of our data. By year’s end, the Film Business Index had posted an annual decline of 12% and the Sheet Business Index was down 8%. In 2009, production of plastics film and sheet will grow moderately, followed by more robust growth in 2010.

As was the case in many manufacturing segments, declines in film and sheet at the end of last year overstated the actual decline in the underlying supply/demand fundamentals that would normally describe these markets. Recessions are self-fulfilling prophecies in which the collective perception of economic conditions becomes far more powerful than reality. So once a bottom is finally established, there will likely be a short burst of demand for most types of film and sheet as expectations are brought back into line with actual activity levels.

This will likely be the scenario during the second half of 2009. After that, increases in demand will be steady but gradual for a few quarters as employment levels ramp up and painful memories of the past recession begin to fade. This represents the start of the period in an economic recovery when the pending expansion becomes the self-fulfilling prophecy. This will not occur until 2010.

In the meantime, we have interest rates at a very accommodating level and the anticipated benefits of an enormous stimulus package. History shows that the trend for changes in film demand turns very early in the 911������ cycle. Most film is used in packaging and other low-cost, non-durable products. Demand for these products is less volatile than those in the durable goods sector.

Film and sheet manufacturers who want to anticipate the start of the next recovery phase must closely monitor the changes in the market’s momentum (i.e. the slope of the chart). A recovery naturally follows a bottoming-out, but because the actual economic activity levels are still quite low by historical standards, managers who ignore the trend of the graph will wait too long before they acknowledge that the recovery has started.

PP PRODUCTS HELD UP BEST

The market for polypropylene films performed much better than other film segments in 2008, and this trend will continue for the foreseeable future. Output of oriented PP film fell by only 3% last year, much less than the average for the film sector. For makers of polyethylene film, demand for food-packaging films held up much better than did non-food packaging and non-packaging products. All of the PP and PE film sectors will enjoy lower average materials prices in 2009 and 2010 than they did in 2008.

Plastics sheet had grown faster than most other plastics industry segments before 2008, and last year the sheet data declined at a slower rate than the overall average. This was mostly due to the performance of polypropylene sheet. In 2008, PP sheet output contracted by 5% while PVC and PE sheet were off by more than 10%.

About the Author

Bill Wood, an independent economist specializing in the plastics industry, heads up Mountaintop Economics & Research, Inc. in Greenfield, Mass. He can be contacted by e-mail at BillWood@PlasticsEconomics.com. His monthly Injection Molding and Extrusion Business Indexes are available at www.ptonline.com.