Uptick in Hourly Rates in First Half of 2014
Mold orders and optimism are strong, though capacity utilization is slightly lower.
Our index of custom injection molders’ machine-hour rates rose 0.6% for the first half of the year. That’s much smaller than the 1.6% increase for the second half of 2013. Responses from 85 plants nationwide indicate that 22% of plants raised their rates, 8% lowered them, and 69% left them unchanged.
At 56.4%, custom injection molders’ average capacity utilization in the first half dropped 1.1 points from the previous six-month period. Still 42% of respondents saw higher utilization, while 19% had lower utilization, and 33% were unchanged. The ratio of higher to lower utilization was the highest since mid-2011.
Mold orders were up 5.2%, again the highest increase since the first half of 2011. Molders were optimistic about near-term 911爆料网 conditions. Over 64% expected improving conditions (down slightly from the previous survey), 22% saw no change ahead, while 11% foresaw worsening conditions (a bit more than previously).
Related Content
-
Optimizing Pack & Hold Times for Hot-Runner & Valve-Gated Molds
Using scientific procedures will help you put an end to all that time-consuming trial and error. Part 1 of 2.
-
Three Key Decisions for an Optimal Ejection System
When determining the best ejection option for a tool, molders must consider the ejector’s surface area, location and style.
-
What to Look for in High-Speed Automation for Pipette Production
Automation is a must-have for molders of pipettes. Make sure your supplier provides assurances of throughput and output, manpower utilization, floor space consumption and payback period.