World's Smallest Hot-Runner Controller
Measuring 97 x 61 x 30 mm and weighing 135 g, you can hold it in your hand.
Measuring 97 x 61 x 30 mm and weighing 135 g, you can hold it in your hand. The new PICCO hot-runner controller mounts directly on the mold and stays put when the mold is moved. Because the heater/thermocouple wires plug directly into it, there are no long cables outside the mold and thus much less noise and signal loss for more accurate control, according to the supplier, Innovative Manufacturing Technology (IMT), part of Meiban Group Ltd., a Singapore molder and moldmaker. PICCO has a selector switch for five standard temperature settings for the most commonly used resins, plus two calibrating screws to fine-tune the settings, if necessary. Each PICCO device has two zones of control and costs $500. Contact John Lim, technical sales manager in Singapore (john.lim@meiban.com).
+65 9664 8469 • imt.com.sg
Related Content
-
How to Start a Hot-Runner Mold That Has No Tip Insulators
Here's a method to assist with efficient dark-to-light color changes on hot-runner systems that are hot-tipped.
-
Hot Runners: How to Maintain Heaters, Thermocouples, and Controls
I conclude this three-part examination of real-world problems and solutions involving hot runners by focusing on heaters, thermocouples, and controls. Part 3 of 3.
-
What You Need to Know About Leader Pins and Bushings
There’s a lot more to these humble but essential mold components than you might suspect. Following the author’s tips could save much time, money and frustration.