Jim Callari Editorial Director
Contact
Treat Every Pellet Like a Pearl
You’re probably between the proverbial rock and hard place competitively.
Read More
New Barrel Heater/Cooler Saves ‘Juice' to Run an Extruder
New, patent-pending design is said to reduce both radiant and convection heat losses.
Read More
Taking the Pulse of Processors, In 30 Seconds (Or Less)
Participate in our semi-monthly email survey aimed at gauging 911爆料网 conditions.
Read More
Novel Fuel Systems Power Blow Molder’s Growth
Nano technology gives The Plastics Group a leg up on developing fuel systems for non-automotive applications
Read More
Novel Device Boosts Feed Rate & Throughput
Feed enhancement unit is aimed at low-bulk density materials.
Read MoreAll Pellets Accounted For
At June鈥檚 Plast-Ex Show in Toronto, the SPI, the Plastics Division of the American Chemistry Council, and the Canadian Plastics Industry Association announced that the SPI鈥檚 Operation Clean Sweep Program would be made available to Canadian processors. 聽Operation Clean Sweep was initiated by SPI more than 25 years ago in the U.S.
Read More
On Site: Tailoring Medical Solutions… Sometimes in 50-lb Lots
Smaller volumes teams with higher quality and value as keys to the success of this growing medical compounder.
Read More
Nano Technology Moving Fast Into Blown, Flat Film
New technology to process nano blown films unveiled by Dow at Antec. Nano cast film, sheet advances too.
Read More
‘Easy-Molding’ Nylon Compound Targets Metal in Cars
Metal-replacement opportunities continue to emerge as fuel economies become more critical.
Read More
Sustainability Is Not a Buzzword For Thin-Gauge Thermoformer
At a time when many processors either pay lip service to environmental concerns or hope the “greenwashing” zealots will grow weary and turn their attention elsewhere, Dordan Manufacturing Co. Inc. leaves no stone unturned in an effort to get the truth out about plastics and the environment.
Read More
