Products
Additives: Flow Enhancer for Nylons, PPA, PBT and PLA
CAI Performance Additives’ ST-PA9 flow enhancer shown to dramatically increase MFI of nylon, PBT, PPA compounds and looks promising for PLA formulations.
Read More
Additives: VOC Extraction Additive Masterbatch for PP, TPO
CAI Performance Additives LDV-1035T boasts ‘permanent’ removal of VOCs during compounding eliminating odors in filled PP and TPO compounds.
Read More
Conveying: Pump is Quiet, Powerful, Energy-Efficient
The multi-stage regenerative impeller design of the new Conair HRG Series vacuum pumps is the key to developing deep vacuum power for conveying plastic pellets over long distances, while keeping noise levels comfortably low.
Read More
Auxiliary Equipment: Insulation Blanket Beats the Heat, Improves Safety
Blankets are also said by processor that uses them to be easy to use and remove.
Read More
Compounding: Continuous Processor Can Run Safely on Empty
Proprietary power transmission design and bearing configuration make this possible.
Read More
Mixing: Inline Rotor/Stator Homogenizers Can Be Moved About
Saves time, money by eliminating the need for multiple mixers separately dedicated to each vessel or product
Read More
Extrusion: Energy-Efficient Dryer for Complex Profiles
Novel system uses compressed air to dry profiles without damaging or distorting them.
Read More
Extrusion: Flex-Lip Die Cuts Resin Use on Capstock Layers
Flexible hinge on multi-manifold EDI Ultraflex Die from Nordson reportedly delivers uniform weatherable layer for PVC siding, saving more than $55,000/yr in capstock cost alone.
Read More
Compounding: Closed-Loop System for Coex Film Reclaim
New system permits reclaim of multi-layer production scrap at rates up to 100%.
Read More
Additive: Non-Nylon Based, Low-Haze Oxygen Scavenger for PET
PolyOne’s ColorMatrix Amosorb 4020G, designed for rigid PET packaging, boasts lower haze and reduced impact on the PET recycle stream.
Read More
Materials: LCPs Designed for Rigors of 5G Cellular Communications, Autonomy
Sumitomo expands portfolio of LCPs with two thermotropic grades with low & consistent dielectric constant, loss tangent at high frequency and more to meet 5G technology evolving requirements.
Read More
Tooling: Rotary Cooling Device for Demolding Rotating Cores
Compact rotary cooling units provide a cost-efficient means to integrate rotating cores into molds, while providing greater cooling for faster cycles.
Read More