Show Us Your Worst Hot-Runner Leaks!
This leak was detected early with automated controls, to be discussed in an upcoming article. Help show what happens if leaks get out of hand.
They can be even worse than the one pictured here. Detecting and stopping a leak when it is at this early stage is one of the points in an upcoming Troubleshooting article, authored by Gammaflux, on how to cure common hot-runner headaches, including how to prevent small leaks from becoming an expensive mess.
To dramatize the importance of early leak detection and intervention, we invite injection molding readers to submit photos of nasty hot-runner leaks to accompany this article. We know you have the leaks and are betting some of you couldn’t resist documenting them. Send your photos to me, Executive Editor Matt Naitove at mnaitove@ptonline.com by Aug. 15. Thanks!
Related Content
-
New Hot Runner Temperature Control
Oerlikon HRSflow’s T-Flow HRS control has launched with three models that are configurable to multiples of six zones.
-
Hasco Marks a Century in Mold Components, Mold Bases and Hot Runners with Cake and New Technologies
NPE2024: Cake, drinks and the unveiling of a new North American website providing online ordering in the U.S. and Canada for the first time are just some of the things happening at Hasco’s booth as it brings its year-long centennial celebration to Orlando.
-
Optimizing Pack & Hold Times for Hot-Runner & Valve-Gated Molds
Using scientific procedures will help you put an end to all that time-consuming trial and error. Part 1 of 2.
